Oil Filter Oil Absorbiing Cotton for Absorb the oil during
Moxibustion or Medical
Oil Absorbing Cotton
Suitable for a few oil fumes, The pollutants of steam,absorb oil,
Be used by
Beaty Fume Extractor (M6001W,M6001DW,M6002W,M6002DW,B1000D)
1. Oil Absorbing Cotton Filter is mainly to absorb a small amount
of gas , water from the exhaust air.
2. To prevent the gas water affect other filters, and then affect
the whole purifying efficiency.
3. Oil Absorbing Cotton Filter is be used by Beaty Fume Extractor
More information for our Fume Extractor:
High-efficient Waterun Four-stage absorbing technology
1. First stage: preliminary- effect filtering layer, it can
efficiently filter over 80 harmful matters large-size duts, smogs
and animal hairs.
2. Second stage: high-efficient filtering layer, it can filter
above 0.3micron granules and ducts.
3. Third stage: activated-carbon filtering layer, it can absorb
harmful gas like radon gas and toluene.
4. Fourth stage: high-efficient filtering layer. It can prevent the
secondary pollution of activated carbon powder.
1. What’s the functions for the filters?
Answers. 1) Pre-Filter/F8 pre-filter: the large-size pad filter can
filter large particles of dust (according the requirement to select
pre-filter or F8)
2) PP Middle Filter/Fiber glass filter: it filters the middle-size,
small size particles bigger powders for prolonging the main
filter's life. (according the requirement to select PP middle
filter or fiber glass filter,can use both, the efficiency better.)
3) Main Filter/Active carbon: it cleans harmful particles and
4) High efficiency filter(combine middle filter and active carbon
filter): it can filter about 0.3micron particles and other harmful
2. What’s the advantage compare with ducted exhaust fan?
Answer: 1. Many advantages like (1) Clean the air quality (2)
energy saving (3) easy installation, flexible remove (4) low cost
(5) reduce the incidence of diseases and major diseases, and health
is priceless (6) to reduce unpleasant smell (7) to reduce dust and
other harmful substances, and so on.
3. What’s the life span of our fume extractor?
Answer: Motor lifetime is (continuous working 24 hours) 20,000
hours, consider environmental factors. Usually it can use 4-5 years
without any problems.
4. The ducts for the fume extractor can be shortened or lengthened?
Answer: It can be shortened or lengthened appropriate; but we
suggest not more than 1.5meter. For multi-station, the total pipe
length should not exceed 10 meters.
5. What’s the best distance between the nozzle and the smokes?
Answer: The distance to be 5-15cm is the best.
6. How long need to to replace the pre-filter, middle filter and the
Answer: 1. Pre-filter : normally needs to replace by 1 months
2. Middle filter: normally needs to replace by 3 months
3. Main filter: normally needs to replace by 6 months.
7. Bent pipe will affect smoke purify?
Answer: Yes, it affect the suction power, it should reduce the bent
8. Can our fume extractor completely filtered poison gas?
Answer: No, there still no any kind of filter can filter out 100%
of poison gas, but you can make a different filter net rate upon